安装工序

  • 01放线、抬板Baseline position,lift up the panel
    01放线、抬板Baseline position,lift up the panel

    在墙板安装部位弹基线与板底或梁底基线垂直, 保证安墙板平直,一块1.5平方的板两个人能搬运自如。 Make sure it is vertical between the installation position base line with panel base or beam base, ensure the

    Details
  • 02.锯板 Cutting Wallboard
    02.锯板 Cutting Wallboard

    根据要求用手提机锯任意切割、调整墙板的宽度和长度,使墙板损耗率降低。 In order to reduce the waste rate,customers can use the hand saw arbitrarily to adjust the width or length of wall board as required.

    Details
  • 03.上浆Sizing
    03.上浆Sizing

    用三角洲专用安装浆料按比例加水调成浆状,用清水刷湿墙板的凹凸槽,再将聚合物砂浆抹在墙板的凹槽和地板基线内。 Add our special installation slurry with water in a certain proportion,turning into a kind

    Details
  • 04.装板 Insert the Wallboard
    04.装板 Insert the Wallboard

    将上好浆的墙板搬到装拼位置,立起,上下对好基线,用铁撬将墙板从底部撬起,用力使板与板之间靠紧。 The mortar-covered wallboard to be moved to the position for assembling,align them with baseline,use crowbar

    Details
  • 05.就位In place
    05.就位In place

    挤靠墙板,使砂浆从接缝中挤出,然后先刮去凸出墙板面接缝处的砂浆,最后用木楔将其临时固定。 Draw the wallboards together so that the excess mortar can be scrapped away.Finally use wood wedge to tempo

    Details
  • 06.校正 Correction
    06.校正 Correction

    用检查平整、垂直度2M的直靠尺、铁撬校正。再用木楔及钢筋上下固定。 After the wallboards preliminary installed,use 2 M ruler to check the vertical and smooth degree;After crowbar calibration,use wood wedge and re

    Details